The Molicel M35A is a very good battery for many mobile applications due to its decent capacity and excellent voltage stability when discharging. The good voltage stability at higher loads bring many advantages, especially for electric drives such as e-bikes, scooters, hoverboards etc. Use in e-cigarettes up to 40W possible.

With the INR18650-M35A Molicel proves its competence and superiority.

Molicel was one of the pioneers of the lithium-ion industry. Molicel batteries are used wherever extreme operation and high reliability are required, customers include NASA, DASA, Dyson, Boeing, etc.The Molicel are only sold through authorised dealers and unlike other manufacturers Molicel is convinced of the safety of the batteries and even officially allows their use in e-cigarettes where the batteries are often pushed to the limit with high pulse loads.

Technical data of the Molicel INR18650-M35A

Comparisons, discharge curves and test runs:

https://www.e-cigarette-forum.com "This is decent consistency and both cells exceed Molicel's minimum and typical capacity values."

Data sheets for the Molicel INR18650-M35A:

INR18650-M35A (data sheet)

IEC(62133) (international standards organisation)

UN (UN38.3)

UL (Safety certification organisation)

SDS (Safety Data Sheet)

Safety instructions:

Lithium cells may only be operated with protective electronics!
Please note that lithium cells may only be used by authorised specialist personnel.
Incorrect handling or short-circuiting may result in fire or explosion.

Further characteristics:

Lithium-ion batteries are thermally stable and are not subject to memory effect.
They work on the basis of lithium and are characterised by a high energy density.

Scope of delivery:

1x Molicel INR18650-M35A - 3500mAh, Lithium-ion battery.

*Other options:

- No selection: Battery cell without options as in the main picture.
- Raised positive terminalBy means of a special welding process, a button (nipple) is welded to the positive pole, raising the flat positive pole by approx. 2 mm, similar to e.g. a normal battery.(for  extra charge).
- Solder tagA metal tongue which is firmly connected to the battery at the plus and minus pole and is used to solder a connecting wire or further batteries to the component.
    U - Both solder tags point in one direction (e.g. for parallel connection or soldering to electronic components)
    Z - Solder tags point in opposite direction. (e.g. for series connection or soldering to electronic components).

Notes on use and distribution.

The industrial cells are intended for further processing.

Notes:

A special charger is required for charging lithium-ion batteries, which charges the batteries according to a special charging procedure. (CCCV = constant current, constant voltage.) The batteries must not be charged above a voltage of 4.2 volts, otherwise there is a risk of fire and explosion. It is advantageous to charge the batteries only up to approx. 4.1 volts, as this significantly increases the service life or the number of charging cycles (possibly up to double). Only lithium ion chargers may be used for charging. However, the cheap chargers sometimes have the disadvantage that they do not switch off safely at the end of the charging process, but continue to charge the batteries with a small charging current, which can be dangerous.

Furthermore, rechargeable batteries and batteries do not belong in household waste! Please dispose of them as prescribed by law at the municipal collection points or in the [usually green] containers provided by retailers.